Wart wap in xxx


Eko informed me that there are no special variables needed for the v2 units.[redhawk - 11/16/07] NOTE: On my V2.0 unit, it has original 2.07 Linksys firmware installed... I first downloaded the latest 3.04 FW from the Linksys site and upgraded to it first.Call of Duty: World at War completely changes the rules of engagement by redefining WWII gaming and thrusting players into the final tension-filled, unforgiving battles against a new ferocious enemy in the most dangerous and suspenseful action ever seen in WWII.No mods were found matching the criteria specified.It was found that it will run but it is a tricky unit to load and have function correctly.Below are a compilation of methods/instructions to assist you with creating a DD-WRT-loaded WAP unit.It should then be recognized as a WAP unit on the status tab.Extract your CFE, edit in your MAC address, et0macaddr = MAC, and il0macaddr=MAC 1. Use your MAC-1 for the lan_hwaddr and your MAC for the wan_hwaddr), then put the CFE back on using the Hairy Dairy Maid or TJTAG utility. You could potentially turn your router into a brick.



If you really want your WAP to have the correct MAC address when it boots up there are 2 methods...simple but not permanent, and one not so simple but permanent.If this setting executed successful you see a message "Your changes have been saved".[ddvelzen - 18/01/08] (do not include these next two lines if it is a V2.0 unit..WAPver variable is not needed except on V3.Simply switched to IE and ran same exact commands at 192.168.1.245, perfect upload 1st try.

Then I could later use Firefox for finishing the configuration.

For V1.x only On the Administration Run then Save as Startup...reboot the unit for the new MAC to take effect.